 |
| Gas tank hold down tabs I used about six of them |
 |
| This part was tough. I couldn't figure out where to mount the master on the Berrien Buggy frame. 3 hose clamps that's it |
 |
| Emergency Brake cable setup on rear disk brakes. After threading the emergency brake cable through, clamp cable to a jack stand, then solder the section to cut. That would keep the cable from coming apart. |
 |
| Notice the clamp on the cable. I don't know what they call it but that"s what holds the emergency brake adjustment. |
 |
 |
| The top of the brake drum is cut for a spacer. Goes between the axle nut and rotor |
| After two seasons of riding around, my clutch cable keeps on fraying and eventually breaking. I was using the standard clutch cable shortening kit that everyone in the buggy sport knows. I think this will be the best setup. Parts are in the hardware store |
 |
 |
| Notice in the picture above there is a crimp between the clamp and the loop. That's to make sure that it doesn't loosen. This tool can be found at any hardware store. |
| New shortening cable setup |
| Updated news rotors now have a longer neck - don't need to cut drum for a spacer |
 |
 |
| Check out the new mirrors we found at a hot rod shop I think they look better than the old ones |